800 266 7310
   
  September 8, 2010        
       
Previous
Return to the Product List
Next

Parallel ATA to Serial ATA Host Mode Bridge Board featuring Marvell 88SA8052 Bridge Controller - IDE-SATA07
 
IDE-SATA07 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8052 Serial ATA bridge Controller.

IDE-SATA07 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.



Original Price : $16.00
You  Save: $1.05 
Price : $14.95

Quantity:


  • Model: IDE-SATA07
 
  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal + Power (7+15 pin) Female Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Mater and Slave
  • Parallel ATA Connector:
    • Male IDC 2X20 pin Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    • IDE Big 4-pin power connector
  • LEDs
    • Power LED
    • SATA PHY Ready LED
    • Activity LED (Pin Header 2pin Pitch=2.54mm)

Package Contents:
• IDE-SATA07
• AC Power Cable
• Overview
1815 E. Wilshire Ave # 906, Santa Ana, Ca. 92705 - Tel: 714 558 1808 Fax: 714 558 3229 - Mon-Fri: 9:00-6:00 (PDT)
Copyright © 2008 CalOptic. All rights reserved. Email: Webmaster@caloptic.com